Look-up in Google Scholar
Full metadata record
Irigoin Cabrera, Ulises Octavio
Morales Aquituari, Claudia de Jesús
Estrada Chapoñan, Jesús Antonio
Monge Sandoval, Alejandro
2022-09-19T12:15:41Z
2022-09-19T12:15:41Z
2022-06-17
http://hdl.handle.net/20.500.14503/1949
Iquitos, la ciudad de la Amazonía peruana, es un lugar aislado del resto del país. Ninguna vía terrestre le conecta con las otras ciudades del Perú. Los agregados para el uso en la construcción consisten solamente en arenas de bajo módulo de fineza. Los agregados gruesos solamente se transportan a la ciudad vía fluvial, resultando que su precio es alto. Arena se emplea, por lo general, en el concreto cemento-arena, el cual es preparado solo con agregado fino. La arena presenta alto valor de superficie específica y por consiguiente mayor requerimiento del agua y en efecto también del cemento. El objetivo de la tesis es investigar el agregado de la cantera La Rinconada ubicada en la orilla del Río Nanay en cercanía del centro poblado Santa Clara del distrito de San Juan Bautista y la influencia del aditivo plastificante SikaPlast 740 en el concreto cemento-arena con este agregado. El cemento corresponde al TIPO I marca SOL. Se preparó tres mezclas patrón sin aditivo con diferentes relaciones agua cemento y tres mezclas empleando el aditivo SikaPlast 740. Se usó tres relaciones agua-cemento con valores de 0.92, 0.76 y 0.62 sin aditivo y con aditivo. Luego se comparó las propiedades mecánicas de los concretos obtenidos. Los resultados de las propiedades del agregado arrojaron un valor muy bajo del módulo de fineza de la arena que fue 0.91, por consiguiente en los diseños de mezcla se apreció un requerimiento de agua muy alto. Concretos con el aditivo plastificante SikaPlast 740 mostraron disminución en la cantidad del cemento empleado 14.42% (1.37 bolsas), 13.70% (1.50 bolsas) y 7.14% (0.94 bolsas) para relaciones 0.92, 0.76 y 0.62 respectivamente. Aunque se logró disminuir la cantidad del cemento y del agua de amasado, la resistencia a la compresión a los 28 días se vio afectada en los casos de relaciones agua-cemento de 0.92 y 0.76 disminuyendo en 17.86% y 13.68%. En el caso de 0.62 hubo un aumento de la resistencia en 8.10%. (es_ES)
Iquitos, the city in the Peruvian Amazon, is a place isolated from the rest of the country. No land route connects it with the other cities of Peru. Aggregates for use in construction consist only of low-modulus fineness sands. Coarse aggregates are only transported to the city by river, resulting in a high price. Sand is generally used in sand-cement concrete, which is prepared with only fine aggregate. The sand has a high value of specific surface and therefore a higher requirement of water and, in effect, also of cement. The objective of the thesis is to investigate the aggregate of the La Rinconada quarry located on the banks of the Nanay River near the Santa Clara populated center in the district of San Juan Bautista and the influence of the SikaPlast 740 plasticizer additive in the cement-sand concrete with this aggregate. The cement corresponds to TYPE I brand SOL. Three standard mixtures without additive were prepared with different water-cement ratios and three mixtures using the SikaPlast 740 additive. Three water-cement ratios were used with values of 0.92, 0.76 and 0.62 without additive and with additive. Then the mechanical properties of the obtained concretes were compared. The results of the properties of the aggregate showed a very low value of the fineness modulus of the sand, which was 0.91, therefore, in the mix designs, a very high water requirement was observed. Concrete with the SikaPlast 740 plasticizer additive showed a decrease in the amount of cement used 14.42% (1.37 bags), 13.70% (1.50 bags) and 7.14% (0.94 bags) for ratios 0.92, 0.76 and 0.62, respectively. Although the amount of cement and mixing water was reduced, the compressive strength at 28 days was affected in the cases of water-cement ratios of 0.92 and 0.76, decreasing by 17.86% and 13.68%. In the case of 0.62 there was an increase in resistance at 8.10%. (En_us)
Tesis (es_ES)
application/pdf (es_ES)
spa (es_ES)
Universidad Científica del Perú (es_ES)
info:eu-repo/semantics/openAccess (es_ES)
http://creativecommons.org/licenses/by-nc-nd/3.0/us/ (*)
Plastificante (es_ES)
Reductor del agua (es_ES)
Concreto cemento-arena (es_ES)
Mortero estructural (es_ES)
Diseño de mezcla (es_ES)
Plasticizer (En_us)
Water reducer (En_us)
Cement-sand concrete (En_us)
Structural mortar (En_us)
Mix design (En_us)
Influencia del aditivo SIKAPLAST-740 PE, en las propiedades físicas y mecánicas del concreto cemento arena, obtenido a partir de arena de la cantera la rinconada distrito San Juan Bautista, Loreto, Perú. 2021 (es_ES)
info:eu-repo/semantics/bachelorThesis (es_ES)
Universidad Científica del Perú. Facultad de Ciencias e Ingeniería (es_ES)
Ingeniería Civil (es_ES)
Titulo Profesional (es_ES)
Ingeniero Civil (es_ES)
PE (es_ES)
https://purl.org/pe-repo/ocde/ford#2.01.00 (es_ES)
http://purl.org/pe-repo/renati/level#tituloProfesional (es_ES)
10190397 (es_ES)
47028702 (es_ES)
https://orcid.org/0009-0007-6168-7415 (es_ES)
https://orcid.org/0000-0002-1616-7601 (es_ES)
47831377 (es_ES)
41770027 (es_ES)
732267 (es_ES)
Wong Ramírez, Félix (es_ES)
Gallardo Sánchez, Nerea (es_ES)
Bautista Serpa, Liliana (es_ES)
https://purl.org/pe-repo/renati/type#tesis (es_ES)
Privada asociativa



This item is licensed under a Creative Commons License Creative Commons