Citas bibligráficas
Esta es una referencia generada automáticamente. Modifíquela de ser necesario
Pantoja, H., Guerra, M., Paita, G. (2022). Half face mask with regulation thermal stability system for continuous air flow: Stabimask [Universidad Continental]. https://hdl.handle.net/20.500.12394/12348
Pantoja, H., Guerra, M., Paita, G. Half face mask with regulation thermal stability system for continuous air flow: Stabimask []. PE: Universidad Continental; 2022. https://hdl.handle.net/20.500.12394/12348
@misc{renati/914421,
title = "Half face mask with regulation thermal stability system for continuous air flow: Stabimask",
author = "Paita Sulluchuco, Gino Rolando",
publisher = "Universidad Continental",
year = "2022"
}
Título: Half face mask with regulation thermal stability system for continuous air flow: Stabimask
Asesor(es): De La Cruz Casaño, Rafael
Palabras clave: Ingeniería mecánica
Campo OCDE: http://purl.org/pe-repo/ocde/ford#2.03.01
Fecha de publicación: 2022
Institución: Universidad Continental
Resumen: This article presents the design and prototyping of an electronic
mask as personal protective equipment for the virus pandemic
known as COVID – 19. Needs were identified such as: tightness
and comfort. Requirements for use for long periods of time; this
was considered for the design, also it has an adjustable ventilation
system. The mask was simulated and validated with Solidworks
Flow Simulation software, in addition a PID control model was
implemented, thereby, it was shown that enough flow is gener-
ated to vary the temperature in a range of 20 to 37.2 ° C inside
the mask. The design considers an outlet duct and an inlet duct
with filters that prevent the entry of polluting particles, providing
adequate protection. The prototype was made by 3D printing, And
the thermal stability was achieved with the implementation of the
temperature regulation system. The results obtained were validated,
and they allow to future research to provide greater efficiency to
masks.
Enlace al repositorio: https://hdl.handle.net/20.500.12394/12348
Disciplina académico-profesional: Ingeniería Mecánica
Institución que otorga el grado o título: Universidad Continental. Facultad de Ingeniería.
Grado o título: Ingeniero Mecánico
Fecha de registro: 16-ene-2023
Este ítem está sujeto a una licencia Creative Commons Licencia Creative Commons