Buscar en Google Scholar
Título: Influencia del tiempo y dosis de polvo de pepa de Mangifera indica L. (Mango) en coagulación-floculación de aguas residuales de la Agroindustria Virú S.A.
Asesor(es): Rivero Corcuera, José Martín; Rivero Méndez, José Félix
Fecha de publicación: 2019
Institución: Universidad Nacional de Trujillo
Resumen: El presente trabajo tuvo como objetivo determinar la influencia de la variación del tiempo de mezcla lenta:10 ,20 y 30 min y la dosis del polvo de la almendra del mango (Mangifera Indica L.) : 3, 5 y 8 g en un proceso de coagulación-floculación utilizando las aguas residuales de la empresa agroindustrial VIRÚ S.A., este proceso se realizó en un equipo de test de jarras en el cual se llevó a cabo 9 tratamientos con 3 repeticiones de 800 ml de muestra de agua para cada uno, luego se agregaron las diferentes dosis del coagulante natural, con un mezclado rápido a 100 rpm por dos minutos, luego una mezcla lenta a 30 rpm a diferentes tiempos y una fase de sedimentación durante 30 min, finalizando con la caracterización de cada muestra tratada, midiendo: turbidez (NTU) , color (Pt – Co) y sólidos suspendidos totales (mg/l). Mediante un análisis de varianza (ANOVA) se determinó que la combinación que influye en la mejora del proceso de coagulación-floculación fue el tratamiento 1, donde se utilizó 3 g de dosis de coagulante en 800 ml de muestra y 10 min de tiempo de mezcla lenta, reduciendo los parámetros físico químicos analizados: turbidez: 95.23%, color: 92.14% y sólidos totales suspendidos: 49.58 %
Nota: The objective of this work was to determine the influence of the variation of the slow mixing time: 10, 20 and 30 min and the dose of the powder of the mango almond (Mangifera Indica L.): 3, 5 and 8 g in a process of coagulation-flocculation using wastewater from the agroindustrial company VIRÚ S.A., this process was carried out in a jar test equipment in which 9 treatments were carried out with 3 repetitions of 800 ml of water sample for each one, then they added the different doses of the natural coagulant, with a rapid mixing at 100 rpm for two minutes, then a slow mixture at 30 rpm at different times and a sedimentation phase for 30 min, ending with the characterization of each sample treated, measuring: turbidity (NTU), color (Pt - Co) and total suspended solids (mg / l). Through an analysis of variance (ANOVA) it was determined that the combination that influences the improvement of the coagulation-flocculation process was treatment 1, where 3 g of coagulant dose was used in 800 ml of sample and 10 min of mixing time slow, reducing the physical and chemical parameters analyzed: turbidity: 95.23%, color: 92.14% and suspended total solids: 49.58%
Disciplina académico-profesional: Ingeniería Química
Institución que otorga el grado o título: Universidad Nacional de Trujillo. Facultad de Ingeniería Química
Grado o título: Ingeniero Químico
Fecha de registro: 24-jul-2019



Este ítem está sujeto a una licencia Creative Commons Licencia Creative Commons Creative Commons