Look-up in Google Scholar
Full metadata record
Panta Mesones, Julio.
Chávez Cabrera, Wileduar David
Muñoz Castillo, Daniel Alejandro
2017-09-27T16:41:03Z
2017-09-27T16:41:03Z
2016-12
https://hdl.handle.net/20.500.14414/8790
In this research the mechanical and microstructural characteristics of an experimental high-strength steel obtained by hot rolling, were studied, both in the raw state of controlled rolling and after tempering heat treatment at subcritical temperatures of 400° C, 500° C and 620° C. Hardness measurements and microstructural analysis in longitudinal and transverse to the rolling direction were made. The results showed a marked anisotropy with respect to hardness. Regarding the microstructure it was determined that the smaller grain size occurs at 620 ° C, corresponding with a higher hardness. Small amounts of martensite and bainite presents distributed irregularly shaped homogenized with heat treatments. (es_PE)
En este trabajo de investigación se estudió las características mecánicas y microestructurales de un acero experimental de alta resistencia obtenido por laminación en caliente, tanto en estado bruto de laminación controlada y luego de tratamiento térmico de revenido a las temperaturas subcriticas de 400°C, 500°C y 620°C. Se hicieron mediciones de dureza y análisis microestructural en sentido longitudinal y transversal a la dirección de laminación. Los resultados mostraron una marcada anisotropía con respecto a la dureza. Con respecto a la microestructura se determinó que el menor tamaño de grano ocurre a 620°C, correspondiente con una mayor dureza. Este acero presenta pequeñas cantidades de martensita y bainita distribuidas de forma irregular que se homogeniza con los tratamientos térmicos, fases características de un acero de fase dual. (es_PE)
Tesis (es_PE)
spa (es_PE)
Universidad Nacional de Trujillo (es_PE)
Tmet 9280;9280
info:eu-repo/semantics/openAccess (es_PE)
http://creativecommons.org/licenses/by-nc-nd/2.5/pe/ (es_PE)
Universidad Nacional de Trujillo (es_PE)
Repositorio institucional - UNITRU (es_PE)
Propiedades Mecánicas en aceros de alta resistencias (es_PE)
Caracterización microestructural y de propiedades mecánicas en aceros de alta resistencia obtenidos por laminación en caliente y con tratamiento térmico de revenido (es_PE)
info:eu-repo/semantics/bachelorThesis (es_PE)
Universidad Nacional de Trujillo. Facultad de Ingeniería (es_PE)
Ingenieria (es_PE)
Título Profesional (es_PE)
Ingeniero Metalurgico (es_PE)
Pública



This item is licensed under a Creative Commons License Creative Commons