Look-up in Google Scholar
Title: Influencia de los parámetros geotécnicos obtenidos a través de ensayos corte directo y triaxial en el diseño de estructuras de cimentaciones superficiales en suelos arenoso-limosos
Other Titles: Influence of geotechnical parameters obtained through direct shear and triaxial tests on the design of surface foundation structures on sandy-silty soils
Advisor(s): Pacheco Miranda, Lidia
OCDE field: https://purl.org/pe-repo/ocde/ford#2.00.00; https://purl.org/pe-repo/ocde/ford#2.01.01
Issue Date: 14-Nov-2023
Institution: Universidad Peruana de Ciencias Aplicadas (UPC)
Abstract: The present investigation carries out an analysis of the influence of the geotechnical parameters obtained through direct and triaxial shear tests on the admissible capacity of silty sandy soils and footing sizing. To start this project, results of its SUCS classification were collected, as well as the special tests mentioned above. Subsequently, a comparison was made through descriptive statistical parameters where 35.35º and 34.50º were obtained as the average friction angle of the direct and triaxial shear tests respectively. Likewise, the average cohesion was 0.20kg/cm2 and 0.15 kg/cm2. Next, the calculation of the admissible capacity was carried out where, by using statistical methods, we concluded that the parameters obtained by the triaxial test yield a higher value than the direct shear test and a greater dispersion is also seen in terms of the allowable capacity values that were obtained by the triaxial test. On the other hand, regarding the average within the sizing of the surface footings there are no significant differences. Finally, a correlation is proposed between the geotechnical parameters from which negative and positive correlation coefficients close to zero are obtained, which means that they do not have a significant direct or indirect relation.

La presente investigación realiza un análisis de la influencia de los parámetros geotécnicos obtenidos a través de los ensayos de corte directo y triaxial en la capacidad admisible de los suelos arenoso limosos y dimensionamiento de zapatas. Para dar inicio al presente proyecto se recolecto resultados de su clasificación SUCS, así como también de los ensayos especiales mencionados anteriormente. Posteriormente se realizó una comparación a través de parámetros estadísticos descriptivos en donde se obtuvo 35. 35º y 34. 50º como promedio del ángulo de fricción de los ensayos de corte directo y triaxial respectivamente. Del mismo modo el promedio de la cohesión fue de 0.20kg/cm2 y 0.14 kg/cm2. A Continuación, se procedió a realizar el cálculo de la capacidad admisible en donde al usar métodos estadísticos concluimos que los parámetros obtenidos por el ensayo de triaxial arrojan un valor más alto que el ensayo de corte directo y también se aprecia una mayor dispersión en cuanto a los valores de capacidad admisible que se obtuvieron por el ensayo triaxial. Por otro lado, en cuanto al promedio dentro del dimensionamiento de las zapatas superficiales no hay diferencias significativas. Por último, se plantea una correlación entre los parámetros geotécnicos de los cuales se obtiene coeficientes de correlación negativo y positivo cercano a cero lo cual significa que no guardan una relación directa o indirecta significativa.
Discipline: Ingeniería Civil
Grade or title grantor: Universidad Peruana de Ciencias Aplicadas (UPC). Facultad de Ingeniería
Grade or title: Ingeniero Civil
Juror: Cardenas Guillen, Jorge Luis; Duran Ramirez, Gary Gary
Register date: 29-Dec-2023; 29-Dec-2023



This item is licensed under a Creative Commons License Creative Commons