Buscar en Google Scholar
Registro completo de metadatos
Eyzaguirre Acosta, Carlos Augusto
Romero Zenteno, Alexander Percy
Batallanos Pozo, Christian Andree
2021-02-22T22:36:31Z
2021-02-22T22:36:31Z
2021-02-22T22:36:31Z
2021-02-22T22:36:31Z
2020-12-04
0000 0001 2196 144X (isni)
http://hdl.handle.net/10757/654609
Existe una gran cantidad de neumáticos desechados cada año, debido al aumento descontrolado del parque automotor. Por lo tanto, el reciclaje y el reutilizo de neumáticos de caucho se convierte cada vez más en una obligación y es por ello que se propone una posible solución utilizando el caucho como reemplazo del agregado fino en construcción. El objetivo de esta investigación fue estudiar las propiedades del mortero con caucho en remplazo del agregado fino en porcentajes de 10%, 20% y 30% tomando como modelo un mortero tradicional. Los ensayos realizados fueron el de conductividad térmica y de resistencia a la compresión, la cual se midió a los 7 y 14 días. Los resultados del ensayo de transmisibilidad térmica indicaron que el mortero con caucho en reemplazo parcial del agregado fino presenta un buen comportamiento como aislante térmico y que a mayor porcentaje de caucho se tiene una menor transmisibilidad térmica a través de los muros. Por otro lado, los resultados del ensayo de resistencia a compresión muestran que el mortero que contiene caucho tiene una menor resistencia que un mortero tradicional, sin embargo, puede ser utilizado para revestimiento de muros y elementos estructurales. (en_US)
There is many discarded tires every year, due to the uncontrolled increase in the vehicle fleet. Therefore, the recycling and reuse of rubber tires is becoming more and more an obligation and that is why a possible solution is proposed using rubber as a replacement for fine aggregate in construction. The objective of this research was to study the properties of the mortar with rubber to replace the fine aggregate in percentages of 10%, 20% and 30%, taking a traditional mortar as a model. The tests carried out were the thermal conductivity and resistance to compression, which was measured at 7 and 14 days. The results of the thermal transmissibility test indicated that the mortar with rubber in partial replacement of the fine aggregate shows good behavior as a thermal insulator and that the higher the percentage of rubber, the lower the thermal transmissibility through the walls. On the other hand, the results of the compressive strength test show that the rubber-containing mortar has a lower resistance than a traditional mortar, however, it can be used for cladding walls and structural elements. (en_US)
Trabajo de investigación (es_PE)
application/msword (en_US)
application/pdf (en_US)
application/epub (en_US)
spa (es_PE)
Universidad Peruana de Ciencias Aplicadas (UPC) (en_US)
info:eu-repo/semantics/openAccess (es_PE)
http://creativecommons.org/licenses/by-nc-sa/4.0/ (*)
Universidad Peruana de Ciencias Aplicadas (UPC) (es_PE)
Repositorio Académico - UPC (es_PE)
Rubber mortar (en_US)
Mortero con caucho (en_US)
Conductividad térmica (en_US)
Conductividad térmica (en_US)
Ensayo de compresión (en_US)
Caucho pulverizado (en_US)
Confort térmico (en_US)
Thermal conductivity (en_US)
Compression test (en_US)
Pulverized rubber (en_US)
Thermal comfort (en_US)
Propiedades del mortero utilizando caucho pulverizado de neumáticos (en_US)
info:eu-repo/semantics/bachelorThesis (en_US)
Trabajo de investigación (other)
Universidad Peruana de Ciencias Aplicadas (UPC). Facultad de ingeniería (es_PE)
Ingeniería Civil (es_PE)
Bachiller (es_PE)
Bachiller en Ingeniería Civil (es_PE)
PE (es_PE)
https://purl.org/pe-repo/ocde/ford#2.01.00 (en_US)
http://purl.org/pe-repo/ocde/ford#2.00.00 (en_US)
https://purl.org/pe-repo/renati/level#bachiller (es_PE)
https://orcid.org/0000-0001-9769-2135 (en_US)
724016 (es_PE)
http://purl.org/pe-repo/renati/type#trabajoDeInvestigacion (es_PE)
Privada societaria



Este ítem está sujeto a una licencia Creative Commons Licencia Creative Commons Creative Commons