Look-up in Google Scholar
Title: Diseño del sistema de extracción mediante un pique inclinado del proyecto de profundización 073 en la unidad minera Los Pircos – Santa Cruz – Perú 2018
Advisor(s): Luque Luque, Elmer Ovidio
OCDE field: https://purl.org/pe-repo/ocde/ford#2.07.05
Issue Date: 29-Oct-2018
Institution: Universidad Privada del Norte
Abstract: RESUMEN El objetivo del presente estudio es diseñar la profundización de un pique inclinado el cual servirá para la extracción de mineral y desmonte de Unidad Minera “Los Pircos”. El material será extraído desde el nivel inferior que tiene como cota Nv. 1950 hacia el Nv. 2000. En primer lugar, determinaremos las características y propiedades del macizo rocoso, el cual nos servirá para analizar si la roca soporta los parámetros de la sección para el desarrollo del proyecto. En segundo lugar, nos enfocaremos en el diseño del sistema de extracción, que comprende: el carro minero U35 a utilizar para el transporte, diseño del pique inclinado (parámetros), el diseño de la estación, el ciclo de trabajo del izaje y el cálculo de la capacidad del motor del winche eléctrico que se va a requerir. Finalmente presentaremos una evaluación económica general del proyecto de profundización, en donde se consideran costos estimados de la operación, valor del mineral probado.

ABSTRACT The objective of the present study is to present the design of the deepening through a sloping shaft to which to serve for the extraction of the ore and dismantle the mining unit "Los Pircos". The material was extracted from the lower level that has as dimension Nv. 1950 towards the Nv. 2000, once the material is at the upper level, a turning system will be designed for which the transport will be faster and less important for the curves, the material will be taken to a surface by a locomotive and U35 mining cars. In the first place, the characteristics and properties of the rock mass will be presented, which will not be used to determine if the rock supports the parameters of the section for the development of the project. Secondly, we focus on the design of the extraction system, which includes: the mining car U35 to be used for transport, inclined picket design (parameters), the design of the station, the work cycle of the lift and the calculation of the motor capacity of the electric winch that is going to be needed. The third stage consists in the operational planning of the extraction system, where the necessary resources were determined and detailed, as well as the sequences of the work cycles for the different activities are described. Finally, we will present a general economic evaluation of the deepening project, which considers the estimated costs of the operation, the value of the mineral tested.
Note: Cajamarca
Discipline: Ingeniería de Minas
Grade or title grantor: Universidad Privada del Norte. Facultad de Ingeniería
Grade or title: Ingeniero de Minas
Register date: 16-Nov-2018; 16-Nov-2018



This item is licensed under a Creative Commons License Creative Commons