Look-up in Google Scholar
Full metadata record
Vildoso Flores, Alejandro
Poma Ariza, Julio Alberto
2020-02-07T22:46:27Z
2020-02-07T22:46:27Z
2020-02-07T22:46:27Z
2020-02-07T22:46:27Z
2020-01-10
Poma, J. A. (2019). Análisis y diseño para la elaboración de concreto f´c=210 kg/cm2 adicionando vidrio reciclado molido como agregado fino según la Norma ACI 211. Lima 2019 (Tesis de licenciatura). Repositorio de la Universidad Privada del Norte. Recuperado de http://hdl.handle.net/11537/23469 (es_PE)
624.1834 POMA 2019 (es_PE)
https://hdl.handle.net/11537/23469
Los Olivos (sede)
El presente trabajo “Análisis y diseño para la elaboración de concreto f´c=210 kg/cm2 adicionando vidrio reciclado molido como agregado fino según la norma ACI 211. Lima 2019”. Tuvo como objetivo determinar el porcentaje adecuado de vidrio molido en el diseño de mezcla, utilizando los ensayos para el concreto tradicional, con un agregado alternativo reciclable, el cual pueda aportar al cuidado del medio ambiente sin perder las propiedades físicas del concreto. De esta manera, se quiere dar un aporte de diseño, además se quiere demostrar, que la adición parcial de vidrio molido en parte del agregado fino, ayudará a la mezcla, a aumentar su resistencia a la compresión. En el Perú, el vidrio reciclado normalmente es utilizado para fabricar más vidrio, rescatando su bajo costo, si este pasara por un proceso de molienda, podría ser utilizado en lugares donde escasea el agregado fino, como en el caso de Selva y afines. El vidrio sódico cálcico puede ser reutilizado dando un increíble beneficio mezclándolo con el cemento, arena, pierda y agua, obteniendo un concreto con mayor grado de resistencia a la compresión, más durable y menor grado de absorción, en su estado endurecido, no obstante, originando un óptimo recubrimiento para el acero y del mismo modo una superestructura sumamente más rígida. Todos los ensayos se realizaron en el Laboratorio N° 01 de ensayo de materiales “Ing. Manuel Gonzales de la Cotera” de la Universidad Nacional de Ingeniería – Facultad de Ingeniería Civil UNI-LEM (Laboratorio Certificado ISO 9001). (es_PE)
The present work "Analysis and design for the elaboration of concrete f'c=210 kg/cm2 adding recycled glass ground as fine aggregate according to ACI 211. Lima 2019". The objective was to determine the appropriate percentage of ground glass in the mix design, using tests for traditional concrete, with an alternative recyclable aggregate, which can contribute to the care of the environment without losing the physical properties of the concrete. In this way, we want to give a contribution of design, in addition we want to demonstrate that the partial addition of ground glass in part of the fine aggregate, will help the mixture, to increase its resistance to compression. In Peru, recycled glass is normally used to make more glass, rescuing its low cost, if it went through a milling process, it could be used in places where fine aggregate is scarce, as in the case of Selva and related. Sodium calcium glass can be reused giving an incredible benefit mixing it with cement, sand, stone and water, obtaining a concrete with a greater degree of resistance to compression, more durable and less absorption, in its hardened state, however, originating an optimal coating for steel and in the same way an extremely more rigid superstructure. All the tests were carried out in the Laboratory N° 01 of materials testing "Ing. Manuel Gonzales de la Cotera" of the National University of Engineering - Faculty of Civil Engineering UNI-LEM (Laboratory Certified ISO 9001). (es_PE)
Tesis (es_PE)
Application/pdf (es_PE)
application/msword (es_PE)
spa (es_PE)
Universidad Privada del Norte (es_PE)
Atribución-NoComercial-CompartirIgual 2.5 Perú (*)
info:eu-repo/semantics/openAccess (es_PE)
https://creativecommons.org/licenses/by-nc-sa/2.5/pe/ (*)
Universidad Privada del Norte (es_PE)
Repositorio Institucional - UPN (es_PE)
Materiales de construcción (es_PE)
Concreto (es_PE)
Vidrio (es_PE)
Estructuras (es_PE)
Análisis y diseño para la elaboración de concreto f´c=210 kg/cm2 adicionando vidrio reciclado molido como agregado fino según la Norma ACI 211. Lima 2019 (es_PE)
info:eu-repo/semantics/bachelorThesis (es_PE)
Universidad Privada del Norte. Facultad de Ingeniería (es_PE)
Ingeniería Civil (es_PE)
Título Profesional (es_PE)
Ingeniero Civil (es_PE)
PE (es_PE)
https://purl.org/pe-repo/ocde/ford#2.01.01 (es_PE)
https://purl.org/pe-repo/renati/level#tituloProfesional (es_PE)
10712728
https://orcid.org/0000-0003-3998-5671 (es_PE)
43171100
732016 (es_PE)
http://purl.org/pe-repo/renati/type#tesis (es_PE)
Privada societaria



This item is licensed under a Creative Commons License Creative Commons